help with card

hi i am very new with my robo and not to sure how to do a card with a name down the side or along the top i need the name MARIE on it or in it!!!!!!!!!!!! it is for a very good friend is there onyone who can help me?????/:(

To help people help you...are you working with robomaster...designmaster...inkscape or.......??
XX
win

i have design master but i was wondering if someone could kindly do it for me i have tried but i am fed up now need some desperate tuition

couldn't attempt to tuition you at the mo.....
I have attached one for you...this will allow you to crease the card in half yourself to get the most out of an A4 sheet of card (crease it so the the name is 'outside' when the card will be folded........if you cut the black first then cut the pink out of another colour card/paper this will allow you to overlap the letters onto the card...suggest you try out in pen mode first....give you an idea of where you are working.....just hitting the pit ..good luck...another more talented scrapper will, I'm sure.... give you better....
XX
Win
ps
have shown you a card I did for evie that may enlighten you a tad...

hi thank you so much for helping me for some reason it will not open i bet you think i am thick(i am !!!!!!!!)

the file thats been posted for you is a designmaster file if you have design master installed on your pc you should just be able to click on the link and then click open and it should open in your dm software

hi sorry about this did as you said and it came up file formate not supported

i think i will go on your site and pay for tution i think that would help me a lot

Is this any good?
There are lots of very good tutorials on the forum. I have downloaded some and prited them off to put them in a folder so they are easier to refer to.

thank you so much its greay

Is this thread still active? I also need help with my card, any advice on what diecut machine to use for floral designs? i had a few diecuts and i find the cuts rough and makes the cut out not usable

You might be better posting this in the Cardmaking forum as this one is for users of Silhouette or Scan n Cut machines