Design Master: Where Things Will Cut

[nannyjan]

Underneaththe set origin box Susi is end point is that set at the same place ie bottom left hand corner as set origin?

Janet

[susibi]

this is what I have - I've not touched anything else regarding the origin
Susibi

[Bas0658]

My carrier sheet won't go back to where it started from. It finishes on the right side but stops about 5mm short of where it started

[susibi]

Mine starts top left ( as you look at the machine) and finishes top left
Susibi

[sandymcc]

I think she means under Plotter Options which is under Cut>Plotting Defaults>Setup. The default for end point was in a different spot for me. I now have the bottom left corner indented for both Origin and End Point. I like the blade returning to the top right corner... which, for some odd reason, corresponds to the bottom left. It's like you need to be looking at your CR from behind to make that corner in the diagrams correspond to the origin on the machine. Hmmm... maybe that's the key to understanding all of this! lol Okay, everyone, please rotate your CR's by 180 degrees! lol

[susibi]

I've honestly not touched anything else - mostly because I forgot!! and yet my blade starts and finishes at the same point!
Susibi

[nannyjan]

Can you tell me what settings you have on this other screen please Susi as I think I may have changed these settings earlier when I was trying to cut in landscape mode?

Thanks for the screen shot I've got mine set the same on that screen but not sure about the other one.

Janet

[nannyjan]

Boo hoo I want mine to start and finish at the same point like Robomaster does - top left, otherwise the old brain gets fuddled ha ha.

Janet

[susibi]

these are the same screens but my start is bottom left and finish is bottom right - yet it starts and finishes top left!! Go figure
This is a pic of my CR set up
Susibi

[nannyjan]

How weird Susi - I think you are the only one who has got it to start and finish in the same place!