DesignMaster: Multi-Cut

[sandymcc]

I made a mistake in another thread. I said that you could use Multi-cut to cut more than one pass. The problem is that Multi-cut only works if you have Pen selected as your tool. It's not set up for Knife. Deep heavy sigh on that one.

BUT, here's how you can get a copy of your image on top of itself. Go to Options>Craft Robo Setup>Preferences and under Duplicates, change both offsets to 0.

Then, when you select an image you can use either Edit>Duplicate or just Ctrl-D to make a copy on top of the original. If you want to verify that there are two, then marquis select the image and check up on the Smart Bar... you should see a 2.

Sandy

[nannyjan]

Thanks Sandy - set that up and checked that it worked.

Janet

[susibi]

thanks I've been looking for that for a while ! I like to have my duplicate exactly on top of my original - makes things easier for mats etc.
Susibi

[stressed]

yes me too, that was going to be one of my question i couldnt understand why it didnt work when i just tried todo a duplicate.

[Josieanne]

Thanks Sandy, that works for me now