Question

[Pink Chocolate]

Am just setting up my new robo and have set the blade, cut out a snowflake and printed and cut out my name. What I want to know now though is if I wanted my name printed onto say scrapbook paper or some sort of fancy papers, how do I do that?? Do I have to cut the paper to size and then put through printer to get registration marks on it?? Im confused now and to be honest the instructions are a bit vague.

Thank you for your help.

[Lucille]

Am just setting up my new robo and have set the blade, cut out a snowflake and printed and cut out my name. What I want to know now though is if I wanted my name printed onto say scrapbook paper or some sort of fancy papers, how do I do that?? Do I have to cut the paper to size and then put through printer to get registration marks on it?? Im confused now and to be honest the instructions are a bit vague.

Thank you for your help.

I would suggest you check out 'help' in the menu at the top, it's not the best in the world, but it does help and you can even learn a few things, there are instructions for printing, have a read and get back to the list if you have any problems.

[Tosca]

Firstly, I would cut your scrapbook paper to fit the carrier sheet. (When you know exactly where your machine cuts, you can use a smaller piece of paper). You do not need registration marks. Go into CR text as normal, type your name, resize as you want, then just cut. You should use the setting for thin media, blue blade, (O' ring may or may not be necessary, that will be trial and error). Hope this helps.