Well, I've been pulling my hair out.
I am trying to do a cut and print.
Every time I do it, the cut is off.
I am cutting just plain card stock. 8.5" x 11".
I am cutting in portrait mode.
The bottom registration marks, cuts right on.
As it cuts towards the tail end the cuts gets more off.
I have everything aligned right. The stock is stuck very well on my carrier.
The cut is off about 2mm high and about 1 mm to the right.
What is going on here?
I get the machine to read the registration marks with no problem.
Then when I set to cut, it cuts alright, just not registered on my print.
HELP!
I think my CraftRobo Pro II is out of calibration.
Anyone know if this is the problem????
How do you calibrate?
It will work fine if I stretch my art work. But I feel I should'nt have to stretch my artwork 2 mm up and 1 mm to the right.
Bookmarks